header file for Storm-Related Pests website


POTENTIAL MOISTURE PROBLEMS

Return to Storm Page
Uncorrected moisture problems in the walls, crawlspace or attic can lead to other serious pest problems, such aswood-decaying fungi or later with wood-boring beetles in framing wood. Mold/mildew growing on wood or insulation can also attract nuisance pests, such as plaster beetles, which can slowly build up in numbers and become a chronic problem. Keep a few important facts in mind:
  • Mold/ mildew on surfaces can pose some health issues and needs to be addressed as quickly as possible. For more information about mold indoors, visit the EPA website.
  • Mold/mildew growing on joists or beams does not mean that wood is decaying (or will decay).
  • Wood-decaying fungi do not grow below the fiber-saturation point (28-30% moisture) of the wood.
  • Problems with woodboring beetles are less likely to occur when the wood's moisture content is below 14%. This level may be difficult to reach immediately. Do not seal up walls until the wood moisture content is as least down to 19%. (preferably closer to 15%)
  • You need a moisture meter to determine if you have excess moisture in your crawlspace, attic or framing wall.

At this point, applying pesticides to correct apparent wood decay is NOT the best solution to the problem. Your priority should be to complete temporary or permanent repairs. If the opportunity is there to appyl a borate product to exposed framing before sheetrock is installed, then it may help protect the wood from wood-destroying insects and wood-decaying fungi (except in the event of flooding which would remove the chemical). The next objective is to allow the wood to dry out as quickly as possible.

It may take some time to get the wood moisture down in a flooded/wet crawlspace or basement, but it is not impossible. Here are a few hints:

  • Make sure crawlspace foundation vents open properly and are clear of debris.
  • If possible, remove standing water from the crawlspace or basement ASAP. Increase ventilation to the crawlspace. This can be a simple matter of opening the crawlspace door or using a fan to pull air OUT of the crawlspace, assuming that weather conditions (and availability of electricity) allow you to do so. You may have to use some large-mesh metal screening over the crawlspace door to keep out animals, such as raccoons, opposums and skunks.
  • Remove and replace place wet insulation in crawlspaces and walls.

mold on wood

wet subflooring and sheetrock

wet hanging insulation



Insect Notes Home Page